300-135 前提条件 & Troubleshooting And Maintaining Cisco IP Networks (TSHOOT)

Cisco300-135 前提条件認証試験の合格証は多くのIT者になる夢を持つ方がとりたいです。でも、その試験はITの専門知識と経験が必要なので、合格するために一般的にも大量の時間とエネルギーをかからなければならなくて、助簡単ではありません。JPexamは素早く君のCisco試験に関する知識を補充できて、君の時間とエネルギーが節約させるウェブサイトでございます。JPexamのことに興味があったらネットで提供した部分資料をダウンロードしてください。

JPexamの300-135 前提条件問題集はあなたの一発合格を保証できる資料です。問題集の的中率はとても高いですから、この問題集だけで試験に合格することができます。信じられなら利用してみてください。不合格になればJPexamは全額返金のことができますから、絶対損にならないです。利用したら300-135 前提条件問題集の品質がわかるようになるので、まず問題集の無料なサンプルを試しましょう。問題集のdemoが無料で提供されますから、JPexamのサイトをクリックしてダウンロードしてください。

300-135試験番号:300-135問題集
試験科目:Troubleshooting and Maintaining Cisco IP Networks (TSHOOT)
最近更新時間:2017-11-03
問題と解答:全125問 300-135 勉強ガイド
100%の返金保証。1年間の無料アップデート。

>> 300-135 勉強ガイド

 

JPexamのCiscoの300-135 前提条件試験トレーニング資料を手に入れたら、我々は一年間の無料更新サービスを提供します。それはあなたがいつでも最新の試験資料を持てるということです。試験の目標が変わる限り、あるいは我々の勉強資料が変わる限り、すぐに更新して差し上げます。あなたのニーズをよく知っていていますから、あなたに試験に合格する自信を与えます。

NO.1 Which of the following characteristics describe the BPDU Guard feature? (Choose all that
apply.)
A. BPDU Guard is used to ensure that superior BPDUs are not received on a switch port.
B. BPDU Guard can be enabled on any switch port.
C. A BPDU Guard port should only be configured on ports with PortFast enabled.
D. A BPDU Guard port receiving a BPDU will go into err-disable state.
E. A BPDU Guard port receiving a BPDU will be disabled.
F. BPDU Guard and PortFast should not be enabled on the same port.
Answer: C,D,E

300-135 対応   300-135 PDF   
Explanation:
Option A is, obviously, valid, since BPDUGuard is a enhancement of thePortFast feature.
Reference: Spanning Tree PortFast BPDU Guard
Enhancement
http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a008009482f.shtml

NO.2 The implementations group has been using the test bed to do a 'proof-of-concept'.
After several changes to the network addressing, routing schemes, a trouble ticket has been opened
indicating that the loopback address on R1 (2026::111:1) is not able to ping the loopback address on
DSW2(2026::102:1).
Use the supported commands to isolated the cause of this fault and answer the following questions.
On which device is the fault condition located?
A. ASW2
B. R4
C. DSW2
D. R2
E. ASW1
F. DSW1
G. R1
H. R3
Answer: D

NO.3 Which of the following are shared distribution tree characteristics? (Choose all that apply.)
A. Uses a rendezvous point.
B. Creates a tree from a central RP to all last-hop routers.
C. Place (*,G) entry in a router's multicast routing to table.
D. Memory requirements are higher for shared distribution tree than for source distribution tree.
E. Place (S,G) entry in each router's multicast routing table.
F. An optimal path is created between each source router and each last-hop router.
Answer: A,C

300-135 予想   300-135 方法   

NO.4 The implementations group has been using the test bed to do a 'proof-of-concept' that requires
both Client 1 and Client 2 to access the WEB Server at 209.65.200.241.
After several changes to the network addressing, routing scheme, DHCP services, NTP services, and
FHRP services, a trouble ticket has been opened indicating that Client 1 cannot ping the
209.65.200.241 address.
Use the supported commands to isolated the cause of this fault and answer the following questions.
What is the solution to the fault condition?
A. In Configuration mode, using the interface port-channel 13, port-channel 23, then configure
switchport trunk none allowed vlan none followed by switchport trunk allowed vlan 10,200
commands.
B. In Configuration mode, using the interface port-channel 23, port-channel, then configure
switchport trunk allowed vlan none followed by switchport trunk allowed vlan 10,20,200 commands.
C. In Configuration mode, using the interface port-channel 13 command, then configure switchport
trunk allowed vlan none followed by switchport trunk allowed vlan 20,200 commands.
D. In Configuration mode, using the interface port-channel 23 command, then configure switchport
trunk allowed vlan none followed by switchport trunk allowed vlan 20,200 commands.
Answer: A

300-135 関連題   300-135 最新版   
Explanation:
We need to allow VLANs 10 and 200 on the trunks to restore full connectivity. This can be
accomplished by issuing the "switchport trunk allowed vlan 10,200" command on the port channels
used as trunks in DSW1.

JPexamは最新のC2150-620問題集と高品質のC-HANAIMP-12問題と回答を提供します。JPexamの300-165 VCEテストエンジンとC9020-563試験ガイドはあなたが一回で試験に合格するのを助けることができます。高品質の1z1-961 PDFトレーニング教材は、あなたがより迅速かつ簡単に試験に合格することを100%保証します。試験に合格して認証資格を取るのはそのような簡単なことです。

記事のリンク:http://www.jpexam.com/300-135_exam.html